![2005 dodge neon drive shaft bad 2005 dodge neon drive shaft bad](https://storage.googleapis.com/apk18/ApkImages/a1/A1_659540_Fro.jpg)
If global good trip counter is not displayed and equal to zero, go to step 12. If global good trip counter is displayed and equal to zero, go to next step. Possible causes are: engine does not start, defective camshaft position sensor or target magnet, defective PCM, or defective connectors or wiring.ġ.Turn ignition on with engine off. DTC may be stored in Powertrain Control Module (PCM) when no signal is received from Camshaft Position (CMP) sensor when crankshaft position sensor signal exists. Try and get it repaired as soon as possible.Cam signal is monitored during engine cranking after a specified number of crankshaft position sensor signals have been detected. Also, the signal may be intermittent now, but it might not be long before it gets worse and your Neon won’t start at all. Be thorough in your inspection of the wiring harness. This is one of the more commonly misdiagnosed codes. It’s not nearly as common as the camshaft position sensor or it’s wiring to have gone bad. If there are no other symptoms other than P0344, and the battery was low/dead, it’s highly likely that’s what caused it.Ī bad starter or wiring issue in the starter system circuit can cause P0344. If you’ve recently tried to start your Neon with a battery like this, that may be what threw the code. P0344 is know to be triggered by a battery that has low/no charge. It will no longer be able to send a signal to the PCM and your Neon will get the intermittent P0344 code.
![2005 dodge neon drive shaft bad 2005 dodge neon drive shaft bad](https://www.2carpros.com/forum/automotive_pictures/12900_cs_1.gif)
The camshaft position sensor itself can go bad over time. You’ll want to look for cracked, burnt, or exposed wiring, and inspect the harness plugs. Make sure that the wiring harness is seated well into the camshaft position sensor and not damaged in any way.Īn inspection of the wiring harness is a great place to start looking for the cause of P0344. If there is an open or short between the wiring harness and PCM, the signal will be intermittent. One of the most common causes of P0344 is wiring related. Here are some of the most common causes of P0344:
#2005 DODGE NEON DRIVE SHAFT BAD DRIVER#
In some cases, the only thing that the driver may notice is the check engine light. The symptoms of P0344 can vary quite a bit. That fault is usually caused by an issue coming from your Neon’s camshaft position sensor, or the sensor itself. P0344 is usually caused by an intermittent electrical fault. The PCM will then trip the check engine light and you’ll get P0344. This information is used to control engine performance and timing, and is checked against the crankshaft position sensor.Īn intermittent signal means that the signal coming from this sensor is failing to reach the PCM at certain points. Its job is to measure the rotational position of the camshaft. Your camshaft position sensor sends a signal back to the PCM when the ignition is on. If your Neon has this code, it means that the PCM (powertrain control module) has detected that the camshaft position circuit is sending an intermittent signal. It is a generic code, which means that it has the same meaning for the Dodge Neon as it would any other vehicle.